Upgrade your rear wheel setup with a dependable, used pair of washers designed for the rear wheel shaft. This set includes both the right-side and left-side washers, clearly labeled as E2, ready to support precise alignment and smooth operation in compatible assemblies.

Why these washers matter for your ride or equipment:

• Precise spacing on the rear axle helps keep the wheel centered, minimizes lateral play, and protects bearings from uneven loads.
• Consistent load distribution across the axle shoulder reduces wear and extends the life of the hub and bearings.
• Cost-effective replacement—useful for repairs, restorations, or routine maintenance where original washers show wear but full replacements aren’t necessary.
• Convenient pair—includes both sides so you can restore proper geometry without hunting for the matching part.

What’s included

• 1 x right-side rear wheel shaft washer (E2)
• 1 x left-side rear wheel shaft washer (E2)

Compatibility and use

• Designed for rear wheel shaft assemblies that require washers on both sides of the wheel hub.
• The E2 designation helps you confirm alignment with your model’s axle hardware and service specs.
• Ideal for DIY maintenance, restoration projects, and as a ready replacement pair for seasonal tune-ups.

Installation notes

• Inspect the washers for any cracks, deformation, or excessive wear before installation.
• Match each washer to its respective side (right vs left) to preserve correct spacing and wheel alignment.
• Clean all mating surfaces and reinstall following your vehicle or equipment’s service manual guidance for torque and seating recommendations.

Condition and care

• Used condition with typical signs of prior installation and handling. Functionally suitable when free of cracks and excessive wear.
• Store in a dry place to prevent corrosion and inspect prior to re-use in any critical braking or wheel-hub area.